Datasheet

NetShelter VX 25U Enclosure 7
Installation
How to Install the NetShelter VX 25U Enclosure
How to level the enclosure
Leveling feet are attached under the enclosure at the corners. The leveling feet help provide a stable
base if the floor is uneven, but they cannot compensate for a badly sloped surface. You can remove
the casters and leveling feet to allow the base of the enclosure to rest directly on the floor.
1. Move the enclosure to a level location.
2. For each leveling foot, fit the 14-millimeter end of
the open-ended wrench (provided) to the hex head
just above the round pad on the bottom of the foot.
Turn the wrench clockwise to extend the leveling
foot until it makes firm contact with the floor.
3. Use a level to determine which feet need further
adjustment to level the enclosure. Adjust them as
needed.
How to remove the casters and leveling feet (optional)
Lay the enclosure on its side.
To avoid personal injury or damage to the enclosure, two people should support the
enclosure.
1. Remove the four hex nuts from each of the casters and remove the casters.
2. For each leveling foot, fit the 14-millimeter end of the open-ended wrench (provided) to the hex
head just above the round pad on the bottom of the leveling foot. Turn the wrench clockwise to
extend and remove the leveling foot.
W
arn
i
ng