User Manual
G-Type Rack Power Filter: Operation10
Power Threshold. The amount of power used by a device in Sleep or Standby mode varies between
devices. It may be necessary to adjust the threshold at which the Master outlet signals the Controlled
outlets to shut down.
1. Ensure a master device is connected to the Master outlet. Put that device into Sleep or Standby
mode, or turn it OFF.
2. Press STATUS and hold for three seconds.
3. The G50 will now recognize the standby power threshold of the Master device and save it as the
new threshold setting. Use the UP or DOWN arrow key to adjust the power threshold.
Green Function. Use the Up and Down arrow buttons to enable or disable the Green Function. The
Green Function allows you to utilize the MASTER and CONTROLLED outlets. When the device plugged into
the MASTER outlet goes into Sleep or Standby mode, or turns off, the equipment that is connected to the
CONTROLLED outlets will also turn off, saving electricity.
Utility Rate. Enter electrical power utility rate in cents/kWh (USD only). The unit unit will use this to
calculate the savings accumulated when using the green function MASTER and Controlled outlets.
Contact Information. This screen can be customized to include the contact information of the A/V
dealer or installer. Push the STATUS button to move the cursor to the next letter and use the Up and Down
arrow buttons to scroll to the appropriate letter.
Maximum and Minimum Voltages. Set the voltage range in which the unit should normally operate.
The unit will protect connected equipment from high and low voltages that are not safe for operation.
Clear Saved Power. Reset the counter for the amount of power that has been saved by the unit.
Restore default settings. Select YES or NO to restore the default settings.
32:(57+5(6+2/'
:
*5((1)81&7,216
',6$%/(
87,/,7<5$7(
FHQWVN:K
:::$3&$9&20
0$;833(592/7
9
0,1/2:(592/7
9
&/($56$9('3:5
<(6
5(6(772'()$8/7
<(6