User Manual

UPS Network Management Card 3 User Guide81
Device IP Configuration Utility
Capabilities, Requirements, and Installation
The Device IP Configuration Utility can discover Network Management Cards (NMC) that do not have an IP
address assigned. Once discovered, you can configure the IP address settings for the cards.
You can also search for devices already on the network by entering an IP range to define the search. The
Utility scans the IP addresses in the defined range and discovers cards that already have a DHCP-assigned IP
address.
For detailed information on the Utility, see the Knowledge Base on the support page of the APC
website and search for FA156064 (the ID of the relevant article).
Knowledge Base article FA156064 also details the use of DHCP Option 12 (AOS 5.1.5 or higher).
System requirements
The Utility runs on Microsoft Windows 2000, Windows Server
®
2003, Windows Server 2008, Windows Server
2012, Windows Server 2016 and on both 32- and 64-bit versions of Windows XP, Windows Vista, Windows
2008, Windows 7, Windows 8 and Windows 10 operating systems.
This utility supports cards that have firmware version 3.0.x or higher and is for IPv4 only.
Installation
To install the Utility from a downloaded executable file:
1. Go to www.apc.com/tools/download.
2. Download the Device IP Configuration Utility.
3. Run the executable file in the folder to which you downloaded it.
When installed, the Utility is available through the Windows menu options.