User Manual

UPS Network Management Card 3 User Guide25
Network on Control menu
Path: Control > Network > Reset/Reboot
Use these options to reset various Network Management Card options and the UI.
Action Description
Reboot
Management
Interface
Restarts the management interface (e.g. the Web user interface, the CLI) by logging
you off.
The UPS and NMC devices are not rebooted.
Reset All
1
Caution:This resets all configurable values to their defaults.
• If you do not select Exclude TCP/IP, all configured values and settings are reset
to their default values, including the setting that determines how this device must
obtain its TCP/IP configuration values and the EAPoL configuration. The default
for TCP/IP configuration settings is DHCP and that for EAPoL access is disabled.
• If you select Exclude TCP/IP, all configured values and settings except the setting
that determines how this device must obtain its TCP/IP and the EAPoL
configuration values are reset to their default values.
Reset Only
1
TCP/IP: Resets only the setting that determines how this device must obtain its
TCP/IP configuration values including the EAPoL configuration which is reset to
disabled. The default for TCP/IP configuration setting is DHCP and that for EAPoL
access is disabled.
Event Configuration: Resets events to their default configuration. Any specifically
configured event or group will also revert to the default value. See “Notification
menu”
UPS to Defaults: Reset only UPS settings, not network settings, to their defaults.
Control Policy: Reset the settings that define how the NMC will respond to alarms
that are detected at the Dry Contact I/O Accessory.
1
Resetting may take up to a minute. The UPS name you configured will not be reset (see
“UPS General screen”).