User Manual

16UPS Network Management Card 3 User Guide
The options below are not available for all UPS devices.
Battery Status
Battery Capacity
The percentage of the UPS battery capacity that is available to support the
attached equipment.
Battery Voltage The DC voltage of the batteries.
External Batteries The number of batteries connected to the UPS, excluding any internal batteries.
Field Description
Nominal Battery
Voltage
The rated voltage capacity of the UPS batteries; the DC voltage that the batteries
are rated to supply when the UPS uses its battery for output power.
Actual Battery Bus
Voltage
The available DC power.
External Battery
Cabinet Rating
The battery cabinet Amp-Hour rating of an external battery source.
Batteries The total number of batteries (both internal and external) that the UPS has.
Bad Batteries The number of “bad” batteries (the batteries that need to be replaced).
Battery Current The current being output from the battery.
Next Battery
Replacement Date
Among the installed UPS battery cartridges, this is the earliest recommended date
for replacing your batteries.
Intelligence Module
Information about the Intelligence Module. You may be asked for this information
(Firmware Revision, Manufacture Date, Serial Number, and Hardware Revision)
when seeking assistance from APC Customer Support.
Input Voltage The AC voltage (VAC) being received by the UPS.
Bypass Input Voltage The AC voltage (VAC) used when the UPS is in bypass mode.
Input Frequency The frequency in Hertz (Hz) of the voltage being received by the UPS.
Frequency The frequency in Hertz (Hz) shared by the input voltage and output voltage.
Bypass Frequency The frequency in Hertz (Hz) of the voltage used when the UPS is in bypass mode.
Output Current The current, in Amps, applied to the load.
Output Frequency The frequency in Hertz (Hz) of the output voltage.
Load Power The UPS load as a percentage of available Watts.
Apparent Load
Power
The UPS load as a percentage of available VA.
Modules
Information about the modules installed in the UPS. You may be asked for this
information (Firmware Revision, Manufacture Date, Serial Number, and Hardware
Revision) when seeking assistance from APC Customer Support.
Power Module
Information about the power module installed in the UPS. You may be asked for
this information when seeking assistance from APC Customer Support.
Field Description