User Manual

UPS Network Management Card 3 User Guide7
Front Panel (AP9641)
Item Description
1
USB ports
Support for UPS firmware updates, see “Update the UPS firmware
from a USB drive (AP9641 only)”.
2
3
Universal I/O ports
Connect temperature sensors, temperature/humidity sensors, and
relay input/output accessory connectors to UIO port. The relay input/
output accessory has two input contacts and one output relay.
4
10/100/1000 Base-T connector Connects the NMC to the Ethernet network.
5
Reset button
Restarts the network management interface. NOTE: This does not
affect the output power of the device in which the NMC is installed.
6
USB console port
Connects the NMC to a local computer, via a micro-USB cable (APC
part number 960-0603), to configure initial network settings or
access the command line interface (CLI).
7
Link-RX/TX (10/100/1000)
LED
See “Link-RX/TX (10/100/1000) LED”.
8
Status LED An LED (light-emitting diode) is a light source. See “Status LED”.
Universal I/O
Reset
10/100/
1000
Network
A 9641 Network Management Card 3P
1
2
USB
Console