User`s guide

5UPS Network Management Card 2 User’s Guide
Front Panel (AP9630)
Front Panel (AP9631)
Item Description

Serial configuration port
Connects the NMC to a local computer to configure initial network
settings or access the command line interface (CLI).

10/100 Base-T connector Connects the NMC to the Ethernet network.

Reset button Resets the NMC while power remains on.

Link-RX/TX (10/100) LED See “Link-RX/TX (10/100) LED”.

Status LED See “Status LED”.
Item Description

USB ports Supports NMC firmware upgrades, see “File Transfers”.


Sensor ports
Connect temperature sensors, temperature/humidity sensors, or relay input/
output connectors that support two input contacts and one output relay.

10/100 Base-T connector Connects the NMC to the Ethernet network.

Reboot button Reboots (resets) the NMC while power remains on.

Serial configuration port
Connects the NMC to a local computer to configure initial network settings
or access the command line interface (CLI).

Link-RX/TX (10/100) LED See “Link-RX/TX (10/100) LED”.

Status LED An LED (light-emitting diode) is a light source. See “Status LED”.
Smart Slot
Universal I/O
Config
Reset
10/100
Network
A 963 Network Management Card 2
P1
1
2
USB
dmp0099a
Universal I/O