User`s guide

65UPS Network Management Card 2 User’s Guide
Device IP Configuration Utility
Capabilities, Requirements, and Installation
The Device IP Configuration Utility can discover Network Management Cards (NMC) that do not have an IP
address assigned. Once discovered, you can configure the IP address settings for the cards.
You can also search for devices already on the network by entering an IP range to define the search. The Utility
scans the IP addresses in the defined range and discovers cards that already have a DHCP-assigned IP address.
For detailed information on the Utility, see the Knowledge Base on the support page of the
www.apc.com website and search for 3061 (the ID of the relevant article).
To use the DHCP Option 12 (AOS 5.1.5 or higher), see Knowledge Base ID FA156110.
System requirements
The Utility runs on Microsoft Windows 2000, Windows Server
®
2003, Windows Server 2012 and on both 32-
and 64-bit versions of Windows XP, Windows Vista, Windows 2008, Windows 7 and Windows 8 operating
systems.
This utility supports cards that have firmware version 3.0.x or higher and is for IPv4 only.
Installation
To install the Utility from the Utility CD:
1. If autorun is enabled, the user interface of the CD starts when you insert the CD. Otherwise, open the
file contents.htm on the CD.
2. Click Device IP Configuration Utility and follow the instructions.
To install the Utility from a downloaded executable file:
1. Go to www.apc.com/tools/download.
2. Download the Device IP Configuration Utility.
3. Run the executable file in the folder to which you downloaded it.
When installed, the Utility is available through the Windows menu options.