User`s guide

52UPS Network Management Card 2 User’s Guide
SNMP Traps test screen
Path: Configuration > Notification > SNMP Traps > Test
Last Test Result: The result of the most recent SNMP trap test. A successful SNMP trap test verifies only that
a trap was sent; it does not verify that the trap was received by the selected trap receiver. A trap test succeeds if
all of the following are true:
• The SNMP version (SNMPv1 or SNMPv3) configured for the selected trap receiver is enabled on this
device.
• The trap receiver itself is enabled.
• If a host name is selected for the To address, that host name can be mapped to a valid IP address.
To: Select the IP address or host name to which a test SNMP trap will be sent. If no trap receiver is configured,
a link to the Trap Receiver configuration screen is displayed. See “SNMP Trap Receivers screen” above.
Remote Monitoring Service
Path: Configuration > Notification > Remote Monitoring
The Remote Monitoring Service (RMS) is an optional service from Schneider Electric that monitors your
system from a remote operation center 24 hours a day, 7 days a week, and notifies you of device and system
events.
To purchase the RMS service, contact your vendor or click on the link on the top part of this screen:
APC RMS Web site.
Registration. Once you have purchased the service, you activate RMS for the NMC. Select Enable APC
Remote Monitoring Service, choose between Register Company and Device and Register Device Only,
complete the form, and click the Apply button.
Use the Reset APC Remote Monitoring Service Registration check box to discontinue the service, whether
permanently or temporarily (for example, if you are moving an NMC).
SNMPv1
Community Name: The name (“public” by default) used as an identifier when
SNMPv1 traps are sent to this trap receiver.
Authenticate Traps: When this option is enabled (the default), the NMS
identified by the NMS IP/Host Name setting will receive authentication traps
(traps generated by invalid attempts to log on to this device).
SNMPv3
User Name: Select the identifier of the user profile for this trap receiver. See
also “User Profiles” under “SNMP screens”.
Field Description