User`s guide

18 UPS Network Management Card 2 User’s Guide
Example 1: To open the output, type:
uio -rc 2 open
Example 2: To view the status of the devices connected to a Dry Contact I/O Accessory that is installed in universal
input/ output port 2, type:
uio -st 2
ups
Some ups options are dependant on the UPS model. Not all configurations may support all options
of the ups command.
Access: Super User, Administrator, Device User
Description: Control the UPS and view status information. See the User’s Guide for information on how
these options relate to that screen.
-disc
<UIO port #> |
<UIO port #>,
<UIO port #> |
<UIO port #>–<UIO port #>
Identify new input contact or output relay connections.
Option Arguments Description
-c
off | graceoff | on |
reboot | gracereboot |
sleep | gracesleep
Configure UPS actions.
-r start | stop
Initiate or end a runtime calibration. A calibration recalculates remaining
runtime and requires the following:
• Because a calibration temporarily depletes the UPS batteries, you can
perform a calibration only if battery capacity is at 100%.
• The load must be at least 15% to guarantee that a calibration will be
accepted.
-s start Initiate a UPS self-test.
-b enter | exit
Control the use of bypass mode. This command is model-specific and
may not apply to your UPS.
Option Argument Description