Installation Manual

Installation Manual
2
The AP9631 Network Management Card includes all AP9630 Network
Management Card features and the following:
• Provides two USB ports, which support upgrading the NMC 2 firmware
from a USB flash drive.
• Supports two universal input/output ports, to which you can connect:
– Temperature (AP9335T) or temperature/humidity sensors
(AP9335TH)
– Relay input/output connectors that support two input contacts and one
output relay (using the AP9810 Dry Contact I/O Accessory, which is
an optional add-on)
The AP9635 Network Management Card includes all AP9630 Network
Management Card features and the following:
• Provides two USB ports, which support upgrading the NMC 2 firmware
from a USB flash drive.
• Supports one universal input/output port, to which you can connect:
– Temperature (AP9335T) or temperature/humidity sensors
(AP9335TH)
– Relay input/output connectors that support two input contacts and one
output relay (using the AP9810 Dry Contact I/O Accessory, which is
an optional add-on)
• Supports Out of Band Management, with dial-in access via modem to the
Management Card’s Console Interface.
• Supports Modbus RTU via the serial RS485 port, in addition to Modbus
TCP/IP.
Devices in which you can install the NMC 2
The Network Management Card 2 can be installed in any compatible device that has
a Smart Slot, including:
• Any Smart-UPS
®
UPS
• Any Symmetra
®
UPS - the Symmetra PX 250 or Symmetra PX 500 UPS
are compatible with AP9635 only.
• MGE
®
Galaxy
®
300, 3500, or 7000
• Expansion Chassis (AP9600)
*
• Triple Expansion Chassis (AP9604)
*