Installation Manual

23
Installation Manual
If the NMC is pre-installed in the UPS, refer instead to “When an NMC has been
pre-installed.” on page 24.
Installing cards in a Symmetra UPS
For more information on Symmetra UPS models that are compatible
with your NMC 2, see KBase article FA237786 on the APC support
website, www.apc.com/support.
If you are installing an NMC without an attached expansion chassis, install that card
in the highest numbered slot, even if you are leaving other slots empty. If you are
using an expansion chassis, see “Installing cards in an expansion chassis” on
page 22.
For Symmetra models with 4, 3, or 2 slots, install each card, starting with the lowest
priority (as listed in the table on page 21) in the lowest numbered slot. Use the
following illustrations to determine model-specific slot numbering.
Note: The AP9612TH and AP9608 cards shown in the following illustrations are
discontinued. AP9608 is replaced by AP9635.
• When 4 slots are available, arranged in a horizontal row, the
lowest-numbered slot is at the right.
• When slots are arranged in a vertical column:
– If 3 slots are available, the lowest-numbered slot is at the top (as
shown in the following illustration).
– If 2 slots are available, the lowest-numbered slot is at the bottom (as
shown in the following illustration).
Comput er
Battery Communications
Comm. 1 Comm. 2
Interface
Display
Comm.
1 2 3 4
Config
21
0 1
TM
AP9607 UPS Interface Expan der
Basic Monitoring Ports
q
q
Management Port
Status
AP96 08 Ou t-of-B and Manag em en t Ca rd
Probes
1 2
Sensor Zones
AP9612TH Environmental Monitoring Card
1 2 3 4
GND
Smart Slot
A963 N
etwork Management Card 2
P1
USB
Config
Universal I/O Universal I/O
Reset
10/100
Network
mph0462