Installation Manual

13
Installation Manual
Local access to the command line interface
For local access, use a computer that connects to the Network Management Card
through the serial port to access the command line interface:
1. Select a serial port at the computer, and disable any service that uses that
port.
2. Connect the provided serial cable (part number 940-0299) from the selected
port on the computer to the configuration port at the NMC.
3. Run a terminal program (e.g. 3rd party terminal emulator programs like
HyperTerminal, PuTTY, or Tera Term) and configure the selected
port
for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control. Save
the changes.
4. Press E
NTER, repeatedly if necessary, to display the User Name prompt.
5. Use apc for the user name and password.
See “Command line interface” on page 15 to finish the configuration.