Datasheet

2 Installation
Installation
The Triple Chassis can connect to any APC device equipped
with an advanced type computer interface port. This includes
certain Smart-UPS and Matrix-UPS products, and any other
management card that duplicates the functions of the UPSs
computer interface port, such as the Share-UPS.
Configurations
• Stand-alone desktop unit
• Mounted in a NetShelter (EIA-310-D) 19-inch
enclosure
Desktop
installation
The Triple Chassis is equipped with rubber feet for desktop use
and can be set up wherever space permits.
1. Place the Triple Chassis in its permanent location. It
should be located within 10 ft. (3.3 m) of the UPS. Make
sure that the front of the unit is accessible.
2. Connect the female end of the cable (940-1000A) to the
9-pin male connector labeled “To UPS” on the front of
the Triple Chassis.
3. Connect the male end of the cable to the 9-pin female
Computer Interface Port on the rear of the UPS.
4. If UPS monitoring is to be used, connect the required
cable (940-0024, not supplied) from the 9-pin
monitoring port on the front of the Triple Chassis to an
appropriate serial port on your computer, or to another
card.
5. If additional power is needed (see "Power Consider-
ations" on page 5), connect the optional power adapter
output to the front of the Triple Chassis.