User Manual

Message Description
access settings needed to access the
device, and that the Timeout value is
appropriate for the network traffic
requirements.
Correct any network connection problem.
Note: If the problem persists, contact APC
Support ( http://www.apc.com/support ).
"Configuration Results" display
This display provides information about the settings that failed to update for a selected
device during a configuration process.
Note: For information about the Status reported for the selected device, see Status
messages: Configuration Status view.
Element Description
Section Name
Identifies the section that includes a setting
that failed to be configured to use the source
settings. For example, SystemModem,
EventLog, and DataLog are three of the
sections under the Advanced Settings
category.
Key Name
Identifies the name of the setting that failed
to be configured to use the source settings.
Expected Value
Identifies the value expected to be reported
for the setting following the configuration
process.
Actual Value
Identifies the value actually reported by the
device following the configuration process.
Note: The setting may not be shared by the
source and destination ( Not Supported
reported for the Expected Value), the two
devices may allow different values, or the
set may have failed for an unknown reason.
You can use Launch to Device, a right-
click option in the Device View and Map
View, to access the device to review its
event log to see if it contains information
about the error, or to review the user
interface at the device to see the available
settings, allowed values.
StruxureWare Central 6.3.0
259