Datasheet

Console Port Server (AP9301, AP9302, AP9303)—Installation and Configuration: Configuration
4 APC Console Port Server Installation and Configuration
5. Type wiz, press ENTER, and follow the on-screen instructions. You must configure the following
settings:
– DHCP enabled/disabled: Disable DHCP
– System IP: The IP address you want to assign to the CPS
– Gateway IP: The IP address of the default gateway
– Network Mask: The subnet mask
6. On the confirmation screen, confirm your parameter settings.
– If they are correct, type
y and proceed to the next step.
– If they are not correct, type
n. Then type c to change any values and reconfirm them.
7. To activate your configurations, type
y. To make the configuration permanent by saving it to flash,
type
y again when prompted.
8. Exit from the terminal emulation program.
9. Use the Web interface of the CPS to change the root user’s password.
10. On the Host Settings page of the Web interface, configure any other basic parameters.
11. To make the changes effective and save them to flash, click on the apply changes button and click
OK in the dialog that appears.
12. The CPS is now configured as a CAS with its assigned IP address and no authentication. You can
use Telnet to connect to the CPS at serial port 1 with the following command:
telnet <assigned_IP_address> 7001
Caution
When setting up a CPS for the first time, always change the password of the root
user as soon as possible after an IP address is assigned. Failure to change the root user’s
password leaves your LAN vulnerable to unauthorized access of the CPS. See “Change
the Root Password” on page 5.
For a detailed description of the parameters, see “Installation and Configuration” in
the User’s Guide.