Datasheet

®
®®
®
USER’S GUIDE masterswitch vm
Launching Com2Telnet
To enable remote monitoring of your MasterSwitch VM unit:
1. Log on to the computer on which you installed the Com2Telnet
software.
2. Make sure you have connected the cable 940-0144 from the
MasterSwitch VM unit to that computer.
3. Run com2telnet.exe.
To begin remote monitoring, open a Telnet session, specifying the IP
address of the MasterSwitch VM unit. For example:
telnet 159.215.12.144
When using Com2Telnet, do not use the Reprogram Firmware option of
the MSVM Firmware menu. See Reprogram Firmware option (not for use
remotely)
N
ote
For users to perform remote monitoring without a
MasterSwitch VM controller by using Telnet, the Com2Telnet
program (com2telnet.exe) must be running on the computer
connected to the MasterSwitch VM unit.