User`s guide

Switched Rack Power Distribution Unit 14
Control console
After you log on at the control console, as
described in “Local access to the control console”
on page 12 or “Remote access to the control
console” on page 13:
1. Choose Network from the Control
Console menu.
2. Choose
TCP/IP from the Network menu.
3. If you are not using a
BOOTP or DHCP
server to configure the TCP/IP settings,
select the Boot Mode menu. Select
Manual boot mode, and then press
ESC
to return to the
TCP/IP menu. (Changes
will take effect when you log out).
4. Set the System
IP, Subnet Mask, and
Default Gateway address values.
5. Press
CTRL+C to exit to the Control
Console menu.
6. Log out (option 4 in the Control Console
menu).
Note. If you disconnected a
cable during the procedure
described in “Local access to
the control console” on
page 12, reconnect that cable
and restart the associated
service.