User`s guide

®
®®
®
USER’S GUIDE kvm switch
30
– If you did not enable Check Firmware Version, the utility installs
the files without comparing the device firmware version with that of
the upgrade files.
5. To abort the upgrade procedure before completion, click Cancel. An
alert message appears warning you that stopping at this point may
cause the device's firmware to be lost. You can continue or abort the
cancel operation.
6. After the upgrade process has completed, a message confirms the
result:
– If the upgrade succeeded, click Finish to close the Firmware
Upgrade Utility.
– If the upgread was unsuccessful, click Yes to retry or No to stop the
process. Click Cancel to close the Firmware Upgrade Utility.
To recover from a "lost firmware" situation, see Firmware
upgrade reset switch.