Specifications

Coaxial Analog KVM Switch/Coaxial Analog KVM Console Extender
11
3. For each server you are connecting to the daisy-chain setup, use a custom
cable set (see “Cable” on page 2) to connect an available server port on one
of the Coaxial Analog KVM Switches to the Keyboard, Video, and Mouse
ports of the server.
4. Apply power to the system. See “How to Apply Power” on this page to
complete the multi-switch installation.
How to Apply Power
To apply power for a multiple-switch system:
1. Plug in the power cable for the first KVM station. Wait for the Analog KVM
Switch to discover and display its station ID on the Station ID LED. The
station ID for the first station is 01.
2. Plug in the power cables for each Coaxial Analog KVM Switch on the
system in order of second station, third station, and so on. In each case, wait
for the station ID to be discovered and displayed on the current Coaxial
Analog KVM Switch before plugging in the next one. The ID for the second
station is 02, the ID for the third station is 03, etc.
3. After all the Coaxial Analog KVM Switches are running, apply power to the
servers.
Turning off and restarting the Coaxial Analog KVM Switch
Always follow this procedure after removing power to the Coaxial Analog
KVM Switch.
1. Remove power from all connected servers.
Note: Unplug the power cord of any server with the Keyboard
Power On function enabled; otherwise, the station continues to
receive power from the servers.
2. Wait 10 seconds, and then plug in the Coaxial Analog KVM Switch.
3. Apply power to the servers only after the Coaxial Analog KVM Switch is
running.