Specifications

Product Description and Inventory
KVM Switch — Installation and Quick Start 3
Front panel (AP5202 shown)
Item Description

Port LEDs Each Port LED provides status information about a corresponding computer
port. Each port has a left (Online) and right (Selected) LED pair. The
following list describes the LED light indicators:
• A GREEN Online LED indicates the corresponding attached computer port
is up and running.
• An ORANGE Selected LED indicates the corresponding attached
computer has the KVM focus. Under normal conditions, the LED is steady.
When accessing its port under Auto Scan Mode, the LED flashes.
• Each time the KVM Switch begins to provide power, it performs a self-test.
The Online and Selected LEDs blink once in succession during the self-
test.

Reset switch Press the recessed Reset switch with a thin object (the end of a paper clip or
ballpoint pen) to perform a system reset.

Disable Remote button Switches between local and remote access to the console.

Remote console To use a remote console, plug the serial cable into the RJ-45 connector. When
both a local and remote console are present, both can access the switch (not
simultaneously).
• Push the Disable Remote button to toggle between the remote and the local
console.
• When the remote console is in control, you can only view through the local
console. When the local console is in control, you can only view through
the remote console.
•The Local and Remote LEDs indicate which console is currently in use.

RJ-11 serial port The firmware upgrade cable plugs into the RJ-11 connector and transfers
firmware upgrade data from the administrator's computer to the KVM
Switch.

Power LED Indicates when the KVM Switch is receiving power.

Station ID LED Displays the station number of the KVM Switch. The station number is a
two-digit number indicating the switch's position in the cascading sequence.

Firmware upgrade reset
switch
The reset switch is in NORMAL position during normal operation or while
performing a firmware upgrade. If the firmware upgrade operation does not
succeed, slide the reset switch to the RECOVER position, turn the KVM
Switch off, and then restart the KVM Switch. Slide the reset switch back to
the NORMAL position, turn off the KVM Switch, and then restart the KVM
Switch.
KVM Switch
1
9
ON LINE SELECTED
2
10
3
11
4
12
5
13
6
14
7
15
8
16
RESE T
DISABLE
REMO TE
LOC AL
REMO TE
REMOTE CONSOL E UPGRAD E
NORMAL RECOVER
F/W UPGRADE
PO WER STA TION ID







