User Manual

5Rack ATS AP44xx Installation and Quick Start

Load Status LED

This LED identifies overload and warning conditions for the ATS. To configure warning thresholds, see

the User Guide on www.apc.com.

Network Status LED

This LED indicates the network status.

10/100 Status LED

This LED indicates the network status of the Rack ATS.

Condition Description

Green The Rack ATS current is below the Near Overload Warning

threshold.

Yellow The Rack ATS current is above the Near Overload Warning

threshold.

Red The Rack ATS current is above the Overload Alarm threshold.

Condition Description

Off The device that connects the Rack ATS to the network is off or not

operating correctly.

Flashing Green The Rack ATS is receiving data packets from the network at 10

Megabits per second (Mbps).

Flashing Orange The Rack ATS is receiving data packets from the network at 100

Megabits per second (Mbps).

Solid Green or Orange The Rack ATS is receiving no network traffic.

Condition Description

Off The Rack ATS is connected to an unknown network.

Solid green The Rack ATS has valid TCP/IP settings.

Flashing green The Rack ATS does not have valid TCP/IP settings.

Solid orange A hardware failure has been detected in the Rack ATS.

Flashing orange The Rack ATS is making BOOTP requests.

Flashing orange and

green (alternating)

The Rack ATS is making DHCP requests.

If you do not use a BOOTP or DHCP server, see “Local access to the command line interface

(CLI)” on page 11, “Remote access to the CLI” on page 11, or the User Guide on