User Manual

15Rack ATS AP44xx Installation and Quick Start

SNMPv3

NOTE:

To use SNMPv3, you must have an MIB program that supports SNMPv3.

For SNMP GETs, SETs, and the trap receivers, SNMPv3 uses a system of user profiles to identify users.

An SNMPv3 user must have a user profile assigned in the MIB software program to perform GETs and

SETs, browse the MIB, and receive traps. The default settings are no authentication and no privacy.

FTP and SCP

You can use FTP (disabled by default) or Secure CoPy (SCP) to transfer downloaded firmware to the

ATS, or to access a copy of the event or data logs of the ATS. See the User Guide on www.apc.com for

details.

To enable or disable FTP Server access, you must be an Administrator. In the Web UI, click

Configuration, click Network, and then click FTP server.

NOTE:

FTP transfers files without encryption. For higher security, disable the FTP server, and transfer

files with SCP. Selecting and configuring Secure SHell (SSH) enables SCP automatically. However, SCP

will not allow a file transfer until the Super User default password (apc) is changed.

NOTE:

You can use FTP or SCP to configure and update the ATS with StruxureWare Data Center

Expert as long as the same protocol is enabled on both the ATS and StruxureWare. See your

StruxureWare Data Center Expert documentation for details.

Manage the Security of Your System

For detailed information on enhancing the security of your system after installation and initial

configuration, see the Security Handbook, available on the APC by Schneider Electric website,