User Manual

Rack ATS AP44xx Installation and Quick Start12

Configure TCP/IP settings in the CLI

1. Log on to the CLI. See “Local access to the command line interface (CLI)” on page 11 or “Remote

access to the CLI” on page 11.

2. Contact your network administrator to obtain the IP address (if needed), subnet mask, and

default gateway for the Rack ATS.

3. Use these three commands to configure network settings. (Text in italics indicates a variable.)

tcpip -i yourIPaddress

tcpip -s yourSubnetMask

tcpip -g yourDefaultGateway

For each variable, type a numeric value that has the format xxx.xxx.xxx.xxx.

For example, to set a system IP address of 156.205.14.141, type the following command and

press

NTER

tcpip -i 156.205.14.141

4. Type exit, and then press

NTER

. The Rack ATS restarts to apply the changes.