Installation manual

InRow RD Fluid Cooled Operation and Maintenance32
Control console
After you log on at the control console, as described in“Local access to the control console” on page 30
or “Remote access to the control console” on page 31:
1. Choose Network from the Control Console menu.
2. Choose
TCP/IP from the Network menu.
3. If you are not using a
BOOTP or DHCP server to configure the TCP/IP settings, select the Boot
Mode menu and then select Manual boot mode.
4. Set the System
IP, Subnet Mask, and Default Gateway address values. (Changes will take effect
when you log out.)
5. Press
ENTER to return to the TCP/IP menu.
6. Press
CTRL+C to exit to the Control Console menu.
7. Log out (option 4 in the Control Console menu).
Note: If you disconnected a cable from the local computer during the procedure
described in “Local access to the control console” on page 30, reconnect that cable and
restart the associated service.