Installation manual

29InRow RD Fluid Cooled Operation and Maintenance
BOOTP. For the Network Management Card to use a BOOTP server to configure its TCP/IP settings, it
must find a properly configured RFC951-compliant BOOTP server.
1. In the BOOTPTAB file of the BOOTP server, enter the MAC address of the Network
Management Card, the IP addresses of the subnet mask, default gateway, and an optional bootup
file name. For the MAC address, look on the nameplate of the InRow RD or on the Quality
Assurance slip included in the package.
2. When the Network Management Card reboots, the BOOTP server provides it with the TCP/IP
settings.
– If you specified a bootup file name, the Network Management Card attempts to transfer that
file from the BOOTP server using TFTP or FTP. The Network Management Card assumes all
settings specified in the bootup file.
– If you did not specify a bootup file name, you can configure the other settings of the Network
Management Card remotely through its Web interface or control console; user name and
password are both apc, by default.
See your BOOTP server documentation to creat a bootup file.