Installation manual

Uniflair LE Accessories Manual76
6. If not already selected, select the Internet Protocol (TCP/IP) check box.
7. Select Properties. The Internet Protocol (TCP/IP) Properties window displays.
8. Select Use the following IP address.
9. Enter the IP address (including the dots): 172.16.0.100
10.Enter the Subnet mask (including the dots): 255.255.0.0
11. Select OK to apply the changes and close the window.
12.Select OK to close the remaining open windows.
C—Proxy
The following procedure provides details on enabling and disabling the network device called the “proxy”
for communication.
1. On the Windows-based PC, select Start at the bottom-left corner of the screen.
2. Select Control Panel. The Control Panel window displays.
3. Select Internet Options. The Internet Properties window displays.
4. Select the Connections tab.
5. Select LAN Settings. The Local Area Network (LAN) Settings window displays.
6. If using a proxy server, click the Use a proxy server for your LAN check box.
7. Enter the Proxy Server Address and Port to be used.
To disable the proxy (if required):
1. Clear the Use a proxy server for your LAN check box.
2. Select OK to apply the changes and close the window.
3. Select OK to close the remaining open windows.
Activating factory network settings
1. Disconnect power to the pCOWeb controller.
2. Press and hold the button on the pCOWeb card and reconnect the power to the controller.
3. Continue to hold for 20 seconds until the Status LED flashes red.
4. Release the button before the Status LED flashes red three times. After a total of three red
flashes, the LED will turn solid green.
5. After approximately one minute, the Status LED blinks green. At this point, the pCOWeb card has
rebooted to the factory settings.
Opening pCOWeb
1. On the PC, open Internet Explorer
®
.
2. Enter the address field (including the dots): 172.16.0.1
3. Press Enter. The pCOWeb main page displays.
NOTE
: If the address is not found, check the Status LED. If solid green, allow more time for the pCOWeb
card to boot. If blinking green, repeat the “Activating factory network settings” on page 76 instructions.
Entering the IP Address/NetMask
1. Select the Go to Administrator area link.
2. Enter the Default Username: admin
3. Enter the Default Password: fadmin (the Administrator Area displays)