Installation manual

Uniflair LE Accessories Manual72
Inventory
Installing the pCOWeb card
Each pCOWeb is uniquely distinguished by its own Media Access Control (MAC) address. The network
administrator may need to check the MAC address of each pCOWeb installed. The MAC address is shown on
the label applied to the connector and on the two labels included in the packaging. Once installed, the pCOWeb
label may no longer be accessible. During installation, use scissors to separate the two labels supplied and
apply one in an easily accessible position near the pCO controller on the electrical panel.
If more than one pCOWeb device is installed, a map of the installation should be created, applying the second
label provided in the packaging onto the map for each pCOWeb corresponding to its physical position. This
provides the network administrator with the required documents on where the pCOWeb devices and
corresponding MAC addresses are located.
1. Disconnect the power supply to the pCOWeb controller.
2. Using a screwdriver, remove and recycle the plastic hatch from the electronic controller
Item Description Quantity

Network controller card 1

Cover 1

Label that includes the required Media Access Control (MAC) address. Remove
one of these labels before installing to access the required MAC address.
1
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Turn off all power supplying this equipment before working on the equipment. All electrical
work must be performed by licensed electricians. Practice Lockout/Tagout procedures.
Do not wear jewelry when working with electrical equipment.
Failure to follow these instructions will result in death or serious injury.
na4563a
na4488a
PLASTIC HATCH