Datasheet

12 NetworkAir RM Air Distribution Unit
Installation
2. With the front of the fan assembly facing the front of the
enclosure, insert the rails on the sides of the fan assembly
into the guides on the guide and rail assemblies.
3. Slide the fan assembly toward the rear of the enclosure
until the rails lock in place.
4. Tighten all the screws holding the guide and rail
assemblies to the vertical rails.
5. Close the front door of the enclosure and, from the rear,
push the fan assembly fully forward until it touches the
front door of the enclosure.
6. Using a 7-mm spanner or nut driver, adjust the stop
bracket to prevent the fan assembly from sliding back
towards the rear of the enclosure.