Datasheet

NetworkAir RM Air Distribution Unit 7
Installation
5. From the front of the enclosure, attach the front guide
and rail flanges to the outside of the vertical rails using
four, M 6 × 12 mm, Phillips pan-head screws and four
plastic washers. Push and hold each bracket firmly
toward the outside of the enclosure when tightening
screws.
6. At the rear of the enclosure, attach the rear guide and rail
flanges to the outside of the vertical rails using two,
M 6 × 12 mm, Phillips pan head screws and two, plastic
washers in the top hole of each guide and rail assembly.
Push and hold each bracket firmly toward the outside of
the enclosure when tightening screws.
7. Mount the stop bracket over the guide and rail
assemblies and install four, M 6 × 12 mm Phillips pan-
head screws and four plastic washers into the two lower
holes of each guide and rail.
8. After the rails are in position retighten any nuts loosened
in step 4.