Installation manual

EcoBreeze System Operation and Maintenance18
The Embedded Display Menus
Some settings are only available by accessing the embedded display for the interface. Confine
any changes to configuration and time out delays. Do not make other changes to the
embedded menus.
The network status screen
To open the network status screen, press and hold the ENTER and LEFT keys for about three
seconds. The password screen will open. The default password is -12. Press
ENTER to cause
the highlighted box to flash, then press the
DOWN key. When you get to -12, press ENTER again
and the menu screen will open.
• These settings are configured at the factory and should not be changed.
• Note the settings for each node. These are the settings you will use if the display
interface must be replaced.
• Press the arrows in the more column to open more pages for each item in the local
column.
N
OTE: Changing the settings can make Module controller data inaccessible to the remote
display interface.
na3682a
Esc
Network Status
local 99 OK >>
node 1 1 - >>
node 2 0 - >>
node 3 0 - >>
node 4 0 - >>
node 5 0 - >>
node 6 0 - >>
address status more
Esc
Network Status
local 99 OK >>
node 7 0 - >>
node 8 0 - >>
node 9 0 - >>
node 10 10 - >>
node 11 11 - >>
node 12 12 - >>
address status more
Esc
Network Status
local 99 OK >>
node 13 13 - >>
node 14 14 - >>
node 15 15 - >>
node 16 16 - >>
node 17 17 - >>
node 18 18 - >>
address status more