Datasheet

Basic Connection Procedures
18 InfraStruXure for Wiring Closets and Computer Rooms
Connect Rack PDUs to the UPS
Route the Rack PDU power cords to the UPS
through the bottom of the enclosures, using the
holes in the enclosures’ vertical posts. Plug each
power cord into an outlet on the UPS, or Rack
PDU Extender. The diagram shows vertical Rack
PDUs; however, you can use any APC Rack PDUs
with plugs that match your UPS outlets, or Rack
PDU Extender outlets. See “Electrical
requirements and safety” on page 7 for
information on the outlet type of each UPS.
Connect UPS Batteries
The Smart-UPS models are shipped with the batteries installed; however, you must make the
necessary connections to energize the batteries before the UPS will operate.
Ensure that the battery modules in the Symmetra RM or Symmetra LX UPS are seated properly.
Configure APC management devices
Your InfraStruXure System can be managed through the APC Network Management Card or through
the InfraStruXure System Manager.
If you have an InfraStruXure System Manager as part of your system, connect each Network
Management card to the InfraStruXure System Manager hub using CAT5 network cables, and
configure the InfraStruXure System Manager.
If you do not have an InfraStruXure System Manager as part of your system, configure the network
settings of each Network Management card in your system.
See also
See the manual included with your UPS for detailed safety and installation
instructions.
See also
See the manual included with your InfraStruXure System Manager for quick
configuration instructions, and see the on-line help on the InfraStruXure System
Manager’s interface for more information on managing the system.
See also
See the manual included with your Network Management Card for quick configuration
instructions and the supporting documentation on the CD for more detailed
information.