Datasheet

Basic Installation Procedures

14 InfraStruXure for Wiring Closets and Computer Rooms

3. Level the enclosures.

Leveling feet are attached under the enclosure at the corners. The leveling feet can help provide

a stable base if the selected floor space is uneven, but cannot compensate for a badly sloped

surface. To level the enclosure:

a. Fit the 14-millimeter end of the open-ended wrench

(provided) to the hex head just above the round pad

on the bottom of a leveling foot. Turn the wrench

clockwise to extend the leveling foot until it makes

firm contact with the floor.

b. Repeat step a for each of the remaining leveling

feet.

c. Use a level to determine which feet need further

adjustment to level the enclosure. Adjust as

necessary.

Install the UPS

Install the UPS in the bottom of the selected rack or

enclosure. (See “Site Planning” on page 10 for sample

configurations.) If you have a Symmetra RM UPS or a

Symmetra LX UPS, install the power and battery

modules after you install the UPS in the rack.

Install the Rack PDU Extender

The Rack PDU Extender is used primarily with

the Symmetra LX UPS and the NetShelter VX

Enclosure. It snaps into the base of the

NetShelter VX rear channel, and occupies the

bottom 2U of space behind the rear vertical

mounting rails.