Specifications

Symmetra PX 48, 96, and 160 kW 400 V and 100 kW 208 V Operation18
Replacement parts
Warning: All safety instructions in the Safety sheet (990-2984) should be read,
understood, and followed prior to handling the system. Failure to do so could result in
equipment damage, serious injury, or death.
Warning: Only trained persons familiar with the construction and operation of the
equipment, as well as the electrical and mechanical hazards involved, may install and
remove system components.
Note: A maximum of two SmartSlots may be used.
Replace a power management card
1. Loosen the two Phillips screws on the sides of the card and carefully pull it out of the enclosure.
2. Install the new card and secure it with the two screws.
Part APC Part No.
16 kW power module for 48, 96 and 160 kW 400 V SYPM10K16H
10 kW power for 100 kW 208 V SYPM10KF
Battery module (four battery units) SYBT9-B4
Battery unit SYBTU2-PLP
SmartSlot relay I/O module (option) AP9610
Modbus/Jbus interface Card (option) AP9622
Network Management Card (option) Go to www.apc.com for a list of Network Management
Cards.
Power distribution module Go to www.apc.com for a complete list of breaker
modules.
Only the cards in these two
locations can be installed.
