Specifications

15Symmetra PX 48, 96, and 160 kW 400 V and 100 kW 208 V Operation
Configuration
System Settings
Set up the network
Change the display interface settings
1. Select Admin and press ENTER. 2. Select Network Setup and press ENTER.
3. Select Mode and press
ENTER. 4. Select Fixed IP Addr to give a specific IP adress
to the UPS system or select one of the other three
methods to obtain an IP adress. In this example
Fixed IP Addr mode is selected.
5. Select IP (Internet Protocol), SM (Subnet
Mask), and GW (GateWay) and change the
settings using the
UP and DOWN arrow keys. Press
ENTER to confirm the changes.
1. Select Admin and press
ENTER. 2. Select Local Interface and press ENTER.
3. Select Display Behavior and press
ENTER. 4. Select Contrast, Key Click, Beeper Vo lum e , or
Check Log Light and change the settings using
the
UP and DOWN arrow keys. Press ENTER to
save the changes.
UPS
Alarms
Power Dist
Switchgear
Environment
Log
Admin
Help
Network Setup
Local Interface
Date/Time
Device ID
Stat:
Mode:
IP:
SM:
Fixed IP Addr
DHCP Only
BOOTP Only
DHCP & BOOTP
IP:
SM:
GW:
UPS
Alarms
Power Dist
Switchgear
Environment
Log
Admin
Help
Network Setup
Local Interface
Date/Time
Device ID
Local Password
Display Behavior
Alarm Beeper
Contrast>4
Key Click>On
Beeper Volume>High
Check Log Light