Specification Sheet

Walls:
An even surface is necessary plaster must be leveled with fine, high quality wall filler.
To bond dust use WAKOL D 3073 Universal Primer diluted 1:2 with water. Minimum
drying time of 24 hours is needed.
Application
Stir adhesive well before use.
Spread adhesive evenly and uniformly on the back of the tile and the subfloor using the
recommended roller. The tiles can be coated and allowed to dry in advance (maximum
24 hours before installation), however the substrate must be coated at the time of
installation, be sure that tiles and subfloor are completely covered. Allow to dry until the
adhesive is clear, dry to the touch and slightly glossy. If you are unsure about the
coverage a second coat may be applied once the first coat is dry.
Clean tools and equipment with water before adhesive cures,
General Information
Do not use adhesive below grade with excessive moisture or hydrostatic pressure.
Acclimatize materials during cold period properly.
Do not use WAKOL D 3540 for vinyl cork flooring.
Disclaimer
The responsibility of the suitability of the adhesive to each individual case cannot be
assumed as the manufacturer has no influence on the proper application of the adhesives
by the installer and or contractor. The directions for use were established on the basis of
research, experiences and tests believed reliable. Any liability on the part of the seller
cannot be derived there from verbal information is subject to written confirmation.