Instruction manual

Instruction manualREVAMP2600

DSP features and audio signal routing

There are 10 possible DSP settings. The settings will be memorized

and recalled when the unit is powered up. 3 of these settings are

meant for low impedance use, the other ones are for 100 volt use

or a combination of low impedance and 100 volt.

5. Channel 2 status led bar and mute switch: when the mute

switch is pressed, the orange “LIMIT – MUTED” led will light

up. This led will also light up when the internal limiter is

activated to avoid the ampliﬁer from being overloaded by high

input signals. The “CLIP – OVERLOAD” led indicates that the

power ampliﬁer is clipping: reduce the input signal at once

whenever this occurs !!! The green “SIGNAL - -40dB” led

will light up when an input signal is present. The red “INPUT

– OVERLOAD” indicates that the input is being overloaded.

Reduce the incoming signal at once !!! This led will blink

when temperature protect is active: in this case the ampliﬁer

will automatically reduce the output power to avoid further

overheating.

6. DSP setting led display: the leds show which of the DSP settings

or combinations have been activated.