Instruction manual

Instruction manualREVAMP2250
15
Technical specifications
Dynamic output power 2 x 350 W @ 4 Ω
Sine wave power per channel 250 W @ 4 Ω (500 msec)
Dynamic output power bridged 700 W @ 8 Ω
Sine wave power bridged 500 W @ 8 Ω
Minimum output load impedance
CH1 and CH2
4 Ω
Minimum output load impedance
bridge mode
8 Ω
Input connections 2 x balanced euroblock, 4 x
unbalanced cinch with pass through
Input sensitivity 0 dBV / 1 V
Input impedance 22 kΩ
S/N ratio >90 dB A weighted
THD ch. 1/2 <0.1% @ 100 W / 4Ω / 1kHz A
weighted
Frequency response 10 – 24 kHz + 0 / - 3dB
Built-in DSP yes
Protection circuits over current, over temperature,
DC offset, AC and DC over- and
undervoltage
Channel separation >74 dB @ 1 kHz
Damping factor > 50 all channels
APC sytem internal compressor and clip limiter
Power amp topology class D
Power supply SMPS