Specifications

[e-mail]
5
4. Network cable connector: connect to a normal computer network. For internet
radio playback, the network must have an accessible broadband internet
connection. The connector has 2 leds for diagnostic purposes: when connected
to a network, the green led will stay lit. When data is being transferred, the
orange led will blink.
5. Wifi antenna: connect the Wifi antenna here.
6. FM antenna: connect the standard FM antenna wire here. When you want to
connect the input to an antenna or cable distribution network, you need to
connect through a galvanic separation transformer designed for FM signals.
Never connect to a cable distribution network without separation transformer
because this may lead to unpredictable behavior and even system damage.
7. Mains fuse: replace only with a fuse of the same voltage and current rating:
250V/500 mAT
8. Mains inlet. Connect to a standard mains receptacle 230VAC/50-60Hz.
Connect the tuner antenna using the wire antenna supplied with the unit. Under
normal conditions, the antenna will guarantee good reception of strong FM radio
stations. If necessary, connect to an amplified antenna or cable network using an
FM signal separation transformer. Never connect the antenna input to a powered
antenna or cable network without separation transformer. Failure to do so will
result in unpredictable behavior or even malfunction and system damage !
Connect the analog output jacks to your system’s line input using standard RCA
cables. The analog output connectors carry the signals from the selected playback
media. Alternatively, connect the optical digital output to your digital playback
system. The optical digital jack is a standard Toslink® optical connector and
carries a digital SPDIF signal from the USB/UPnP/internet radio. Turn the output
level potmeter to a position that suits your needs.
Getting started
FM Antenna:
Signal output