Specifications
WWW.APART-AUDIO.COM
2
1
2
3
4
5
6
7
8
9
10
12 14 15
16
11 13
1. Microphone 1 TRS input jack. this jack has a XLR mirror connector at the back. You can use the XLR or the front
jack, but not both simultaneously. You can apply phantom power by closing jumper JP1 inside the device, contact a
qualied technician to do this.
2. Vox/Ext.mute switch. when this switch is pressed, you activate the vox or ‘voice-over’ mute function on mic 1,
the vox level can be set at the rear. When the switch is out, i.e. not pressed, you can activate mute with an external
switch, the ext. mute connector is also at the back.
3. Mic 1 level controller.
4. Mic 2 level controller.
5. Microphone 2 TRS input jack. this jack has a XLR mirror connector at the back,. You can use the XLR or the front
jack, but not both simultaneously. You can apply phantom power by closing jumper JP2 inside the device, contact a
qualied technician to do this.
6. Mic 1 and 2 bass tone control. for better speech intelligibility, gently cut low frequencies. A low cut lter to avoid
popping noises is already built-in and can not be deactivated.
7. Mic 1 and 2 mid tone control..
8. Mic 1 and 2 treble tone control.
9. Mains power switch and power led. when you switch the device on, the blue led will indicate that the power is on.
10. Music or line input bass tone control.
11. Music or line input mid tone control.
12. Music or line input treble tone control.
13. Music or line source volume control. Normally this level controller is turned fully clockwise, however, in some
cases it can be usefull to obtain a good loudness balance between music or line inputs and mic inputs.
14. Music or line level input selector. with this rotary switch you can select between line 1-6 stereo line level inputs.
15. Zone 1 volume control with L/R signal indicator leds. use this level controller as the main zone 1 volume control-
ler. The leds will light up when a strong signal is present at the zone 1 output.
16. Zone 2 volume control with L/R signal indicator leds. use this level controller as the main zone 2 volume control-
ler. The leds will light up when a strong signal is present at the zone 2 output.