Specifications

Table Of Contents

Presets



Apresetisasetofstoredvalues.ThesevaluesareMusicLevel,MicLevelandSourceSelectionforzone

1and/orzone2.Apresetcanbestored,recalledorcleared.Theonlywaytostoreapresetisbyusing

theRS232interface.Apresetcanberecalledusingthesameinterface,usingthecontactsattheback

sideofthePM1122orwithanEasywaveRFswitch,ifbuttonsAtoDareassignedaspresetselector

knobsinsteadofsourceselectors,asdescribedearlier.



Preset0canonlyberecalled(cannotbeoverwritten)andthiswillsetalllevelsattheminimumand

sourceselectionsatsourceA.Itcanonlyberecalledbytheserialinterface.



StoringapresetwillcopythecurrentsettingstotheinternalmemoryofthePM1122‐INT.Itispossible

tosaveonlythesettingsofonespecificzone.Afewexamples:

• “STRPRESET2\n”willstoreallsettingstopresetnumber2forzone1ANDzone2.

• “STRPRESETZONE13\n”willstorethesettingsofzone1topreset3.Whenpreset3willbe

recalled,onlyzone1willchange.



ApresetcanbeoverwrittenbystoringatthesamepresetnumberorclearedbytheCLRcommand.



Recallingapresetwillchangethevaluestothoseofthecorrespondingmemorylocation.Againafew

examples:

• “RCLPRESET2\n”willrecallthesettingsasstoredinpreset2(e.g.ifthepresetisvalidforboth

zones,thenthestoredsettingswillbeappliedtoBOTHzones).

• “RCLPRESETZONE20\n”will putthelevelsofzone2totheminimumandsourceofzone2to

“A”.

• “RCLPRESETZONE11\n”will applythepresetnumber1settingstozone1only,evenifthe

presethasbeenstoredasazone1and2preset.



PresetscanalsobeselectedbyconnectingwiredremotesusingthecontactsCOMAanBandthe

contactslabeled1to6.Theyarepresentatthebackoneuroblockconnectors.

AfirstpresetselectorwiredtoCOMAandtocontacts1to6willenableyoutorecallpresetsnumbered

1to6,whereCOMAisthecommonwireontheselectorandcontacts1to6arethecontactsoperated

bytherotaryselector.

AsecondpresetselectorwiredtoCOMBandtocontacts1to6 willenableyoutorecallpresets

numbered7to12.

Pleasenotethatyoucanspecifywhetherornotthepresetsselectedbythewiredselectorsarebeing

selectedatpowerupwiththe“SETROTARYATSTARTON”or“SETROTARYATSTARTOFF”setting.

