Specifications

WWW.APART-AUDIO.COM
6
1)Channel4unbalancedinputoncinchconnectors:usethetoporbottomcinchconnectortoapplyan
unbalancedsignalonchannel4.Theseconnectorsarewiredinparallel,thismeansyoucanusethesecond
connector as a signal link connector.
2)Channel3unbalancedinputoncinchconnectors:usethetoporbottomcinchconnectortoapplyan
unbalancedsignalonchannel3.Theseconnectorsarewiredinparallel,thismeansyoucanusethesecond
connector as a signal link connector. In case of bridge operation of channel 3 and 4, use this connector and
leave channel 4 input unused.
3)Modeswitch:enablestoswitchtonormal2channelstereooperation,2channelsmixedandeachplaying
this mono mix, or single channel bridge mode. In case of bridge mode, only the channel 3 volume control is
used.Thisisindicatedbythebridgeledonthefrontpanel.
4)Groundliftswitch:usethisswitchtoliftorconnectaudiogroundtosafetyground.Thiscanbeusefullincase
of hum.
5)To p switch:whenpushedin,anactivehighpasslterat100Hz,12dB/octaveisappliedtochannels3and4,
when not pushed in, channels 3 and 4 operate as full range channels.
6)Channel4speakerbindingpost:thisconnectoracceptsspeakercableaswellas4mmbananaplugs.
Remove the protective cover from the middle of the red/black binding post in case you want to use banana
plugs. For bridge mode applications, you MUST use the red binding posts only: channel 4 red plug is
bridge mode negative speaker connector.
7)Channel3speakerbindingpost:thisconnectoracceptsspeakercableaswellas4mmbananaplugs.
Remove the protective cover from the middle of the red/black binding post in case you want to use banana
plugs. For bridge mode applications, you MUST use the red binding posts only: channel 3 red plug is
bridge mode positive speaker connector.
8)Mainscableconnector:plugthemainscableconnectorhere,this
socketalsocontainsamainsfuseholder.
Replace this fuse only with the type as indicated on the rear panel.
9)
Channel2speakerbindingpost:thisconnectoracceptsspeakercableaswellas4mmbananaplugs.
Remove the protective cover from the middle of the red/black binding post in case you want to use banana
plugs. For bridge mode applications, you MUST use the red binding posts only: channel 2 red plug is
bridge mode negative speaker connector.
Rearpanellayout:
1 2 3 4 5 6 7 8 9 10 11 12 13 14