SDS

Product Code: 105812-1636 SDS for: Wood-As-New 1:5 Apache Part #: 99002101
SDS Revision: 06 Generated: 05-14-2015 Page 4 of 6
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Chemical Name / CAS No. OSHA Exposure Limits ACGIH Exposure Limits Other Exposure Limits
Oxalic acid
144-62-7
< 10 %
1 mg/m3 TWA
2 mg/m3 STEL
1 mg/m3 TWA
NIOSH: 1 mg/m3 TWA
2 mg/m3 STEL
Trade Secret/Proprietary Blend
< 7 %
N/A N/A N/A
Water
7732-18-5
Balance %
N/A N/A N/A
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation or other engineering controls to
keep worker exposure to airborne contaminants below any recommended or statutory limits.
If engineering controls do not maintain airborne concentrations below recommended exposure limits (where
applicable) or to an acceptable level (in countries where exposure limits have not been established), an
approved respirator must be worn.
VENTILATION: Use only with adequate ventilation.
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be
matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering
controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been
established, maintain airborne levels to an acceptable level.
ADMINISTRATIVE CONTROLS: No action shall be taken involving any personal risk or without suitable training.
PROTECTIVE GEAR:
Eye protection: Wear safety goggles if eye contact is possible (face shield recommended if splashing is
possible).
Hand protection: Chemical-resistant, impervious gloves complying with an approved standard should be worn at all
times when handling chemical products if a risk assessment indicates this is necessary. Considering the parameters
specified by the glove manufacturer, check during use that the gloves are still retaining their protective properties. It
should be noted that the time to breakthrough for any glove material may be different for different glove manufacturers.
In the case of mixtures, consisting of several substances, the protection time of the gloves cannot be accurately
estimated.
Body Protection: Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before handling this product.
Other Skin Protection: Appropriate footwear and any additional skin protection measures should be selected based
on the task being performed and the risks involved and should be approved by a specialist before handling this product.
Respiratory Protection: If needed, use a properly fitted, air-purifying or supplied air respirator complying with an
approved standard if a risk assessment indicates this is necessary. Respirator selection must be based on known or
anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator.
CONTAMINATED GEAR: Routinely wash work clothing and protective equipment to remove contaminants.