Datasheet

Serial ATA Flash Drive
APS25AXXxxxx-XTM
1
©2013 Apacer Technology Inc. Rev. 1.1
Features:
 Compliance with SATA Revision 3.1
– Serial ATA Revision 3.1
– SATA 6.0 Gbps interface
– Backward compatible with SATA 1.5 and
3.0 Gbps interfaces
– ATA-8 command set
 Capacities
– Standard type: 16, 32, 64, 128, 256 GB
– High-speed type: 32, 64, 128, 256 GB
 Performance*
– Burst read/write: 600 MB/sec
Standard type:
– Sustained read: up to 385 MB/sec
– Sustained write: up to 170 MB/sec
High-speed type:
– Sustained read: up to 450 MB/sec
– Sustained write: up to 430 MB/sec
– Random read (4K): up to 63,000 IOPS
– Random write (4K): up to 63,000 IOPS
 Flash Management
– Built-in hardware ECC, enabling up to 40
bit correction per 1K bytes
– Static/dynamic wear leveling
– Flash bad-block management
– S.M.A.R.T.
– Power Failure Management
– ATA Secure Erase
– TRIM
 NAND Flash Type: MLC
 Temperature ranges
– Operating: 0°C to 70°C (32 ~ 158°F)
– Storage: -40°C to 100°C (-40° ~ 212°F)
 Supply voltage
– 5.0 V 5%
 Power consumption (typical)*
Standard type:
– Active mode: 385 mA
– Idle mode: 105 mA
High-speed type:
– Active mode: 665 mA
– Idle mode: 70 mA
 Form factor
– 2.5”
– Dimensions with 7mm enclosure:
100.00 x 69.85 x 6.90, unit: mm
– Dimensions with 9.5mm enclosure:
100.00 x 69.84 x 9.30, unit: mm
 Connector
– 7-pin SATA signal connector
– 15-pin SATA power connector
 Shock & Vibration**
– Shock: 1500 G
– Vibration: 15 G
 DRAM cache for enhanced random
performance (for high-speed type only)
 SATA power management modes
 Device Sleep mode (optional)
 RoHS compliant
*The values addressed here are typical and may vary depending on settings and platforms.
**Non-operating