User Manual

18
PROBLEM 1: THE UNIT HAS NO POWER
1. Check if the unit is switched ON.
2. Check the fuse. Replace with the same type if fuse is blown.
3. Check the power cord and make sure there are no disconnections.
4. Verify that the unit is properly connected to the power source.
PROBLEM 2: TEMPERATURE DISPLAY IS ALWAYS ABOVE 500
o
C
Description: Constant display of above
500
o
C temperature from the panel C3 then
displays a blinking “OFF” on display panels C2
and C3 after a few minutes.
SOLUTION:
The thermal sensor may be broken and needs to be replaced.
PROBLEM 3: ACTUAL AIR TEMPERATURE IS NOT INCREASING
Description: Actual temperature reading is not increasing or decreasing
based on desired level (set temperature). The panel will then display a
blinking “OFF” on display panels C2 and C3 afterwards.
SOLUTION:
The heating element may be broken and needs to be replaced.
PROBLEM 4: BANNER OR PRODUCT NAME IS ALWAYS SCROLLING - THE
UNIT IS NOT USABLE
Description: The product name is just always scrolling from the digital
panel, rendering the device unusable.
SOLUTION: Press “Reset” from the panel. Note that resetting the device
will also reset all previously defined configurations. If the problem persists,
contact the vendor.
BASIC TROUBLESHOOTING GUIDE
3
PACCKAGE INCLUSIONS
Main Station ……………………………… 1 unit
G001 IC Popper ……………………………… 1pc.
Soldering Iron with Smoke Absorber …………… 1pc.
2660 Soldering Iron Holder
with Solder Wire Stand …………… 1pc.
Hot Air Gun and Hot Air Gun Holder …………… 1pc.
Power Cord ……………………………… 1pc.
Filter Vacuum Cap ……………………………… 1pc.
Suction Vacuum Cap ……………………………… 1pc.
Black Filter Pad (round) ……………………………… 1pc.
1124 Air Nozzle ……………………………… 1pc.
1130 Air Nozzle ……………………………… 1pc.
1196 Air Nozzle ……………………………… 1pc.
1313 Air Nozzle ……………………………… 1pc.
1197 Air Nozzle ……………………………… 1pc.
Instruction Manual ……………………………… 1pc.
Soldering Iron Assembly Guide …………… 1pc.