Instruction manual

18
CARE and MAINTENANCE
Part No. Description
10094 Hot air gun heating element
30106S Plastic handle of hot air gun
S009 Hot air gun complete handle
20962 Hot air gun metal pipe
B012 Soldering Iron complete handle
C005 Desoldering gun heating element
3072D Plastic handle of desoldering gun
B1003 Desoldering gun complete handle
Spare Parts Guide
Blower/Vacuum Air Terminal Filters
Filters should be cleaned and replaced regularly to avoid dirt which can clog the
air passage. More importantly, this will also effectively clean the toxic fumes
produced during soldering process.
Soldering Iron Tip
Always keep the solder-plated section of the tip/nozzle coated with a small
amount of solder. Oxide coating on the tip of the nozzle reduces its heat
conductivity. Coating the tip with a small amount of fresh solder ensures
maximum heat conductivity is obtained.
Replacing the Soldering Iron tip
1. Always turn OFF main power switch when removing or inserting a tip.
2. If the tip is hot, use the heat resistant pad to pull it out.
3. Insert the new tip fully into the handle. If the tip is not fully inserted (or if
the tip is damaged), the device will display “PLUG”. Indicating a problem
with the contacts of the soldering iron or the tip.
Replacing the heating element of the Hot Air Gun
The heating element is found in the middle part of the hot air gun. The
normal life of a heating element is 1 year under normal operating conditions.
Steps:
1. Loosen the 3 screws that secure the handle.
2. Slide off the plastic tube.
3. Disconnect the ground wire sleeve.
7
ASSEMBLY and PREPARATIONS
Figure 1. Soldering iron stand with solder wire holder
A. Main Station
As soon as the equipment has been removed from the package,
REMOVE THE SCREW located at the center of the bottom of the
main unit. This screw holds the pump in place during transportation.
B. Soldering Iron
1. Install the solder wire to the soldering iron holder as in Figure 1.
2. Connect the soldering iron cord assembly to the 6-pin output
terminal found at the lower middle portion of the main unit.
3. Place the soldering iron to the soldering iron stand as shown
above.
C. Smoke Absorber
1. Attach the smoke absorbing tube to the suction vacuum cap.
Make sure the cord connections are free from tangles.
D. Hot Air Gun
The Hot Air Gun holder was installed on the station upside down for
packaging purpose. To set up the Hot Air Gun holder:
1. Loosen the two screws that secure the holder to the station.
2. Turn the holder right side up.
3. Re-fasten the two screws.
4. Place the hot air gun onto the holder in preparation for usage.
E. Desoldering Gun
1. Connect the cord of the desoldering gun to the 6-pin terminal .
2. Connect the vacuum tube to the suction vacuum cap.
3. Place the desoldering gun onto the holder in preparation for
usage.
WARNING: Failure to remove the screw before using the
equipment can cause damage to the system.