Instruction manual

6
SAFETY PRECAUTIONS
CAUTION: Improper usage can cause serious injury to personnel
and/or damage to equipment. For your own safety, please observe
the ff. precautions.
● Check each component after opening the package to make sure
everything is in good condition. If there are any suspected damage,
do not use the item and report the issue to your vendor.
● Turn OFF the main power switch and unplug the device when
moving the device from one location to another.
● Do not strike or subject the main unit to physical shock. Use
carefully to avoid injury and damage to any part.
● Handle with care.
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
● Make sure the equipment is always grounded. Always connect
power to a grounded receptacle.
● Temperature may reach as high as 480°C when switched ON.
- Do not use the device near flammable gases, paper and other
flammable materials.
- Do not touch heated parts, which can cause severe burns.
- Do not touch metallic parts near the tip.
● Disconnect the plug from the power source if the unit will not be
used for a long period.
- Turn off power during breaks, if possible.
● Use only genuine replacement parts.
- Turn off power and let the unit cool before replacing parts.
● The unit may produce a small amount of smoke and unusual odor
during initial usage. This is normal and should not yield any
negative result when reworking.
● Soldering process produces smoke — use on well ventilated place.
● Do not alter the unit, specifically the internal circuitry, in any
manner.
19
CARE and MAINTENANCE
4. Inside the pipe, the quartz glass and heat insulation are installed.
Loosen the cable and take out the heating element.
5. Insert new heating element and reconnect the terminal. Be careful not
to rub Heating Element wire.
6. Reconnect the ground wire after replacing the element.
7. Assemble the handle again.
Soldering Iron Error Messages
1. Soldering Iron connection assembly is not connected or not
properly connected to the receptacle on the control panel.
2. Soldering iron tip is damaged and needs to be replaced. The
device will display “PLUG”.
3. Indicating a problem with the contacts of the soldering iron or
the tip.
De-Soldering Gun
1. Before usage dampen the filter pads with a little bit of water to allow efficient
air passage and filter action, re-dampen pads frequently for maximum
efficiency.
2. Routinely clean Spring Filter, and replace filter pads when they are dirty or
clogged .
3. The solder pathway can be cleaned using the provided Nozzle cleaning pin, use
the cleaning pin when pathway seems clogged.
De-Soldering Gun Disassembled illustration:
Filter barrel
cap
Spring Filter
Filter Barrel
Filter Pads
Filter Dock
De-soldering Gun Body
Heating
element
Nozzle
Securing lock
Heater external
housing