Instruction manual

14
AUTO SLEEP FUNCTIONS
1. While the hot air gun is on stand-by mode (“0FF” is displayed on
the panels “13” and “12”), hold both UP and DOWN buttons of
the HOT AIR GUN TEMPERATURE
adjustment buttons.
2. Wait until “t005” is displayed on the Hot Air Gun Temperature
display panel, “13”.
3. Release the buttons when “t005” appears.
4. Adjust the time using the same UP and DOWN buttons of the
HOT AIR GUN TEMPERATURE
adjustment buttons.
5. Confirm the change by activating the HOT AIR GUN
function
switch.
6. The system will immediately switch back to operation and use the
defined countdown parameter for the entire usage.
NOTES:
● The sleep mode timer is configurable between 1 and 30 minutes.
● Sleep mode settings for Hot-Air gun and Soldering Iron is saved
into the memory an shall remain effective until it is reset or new
data is entered.
G. Activating Soldering Iron Auto-Sleep Mode
The soldering iron’s SLEEP mode is deactivated by default. Follow
the set of procedures below to activate this feature.
CONDITION:
SOLDERING IRON function is inactive.
1. While soldering iron is displaying “OFF” or in stand-by mode, push
both UP and DOWN buttons of the SOLDERING IRON
TEMPERATURE adjustment buttons (“4” from the CONTROL PANEL
GUIDE page).
2. Wait until “t0FF” appears from soldering iron temperature display
panel. This means sleep mode is currently turned OFF.
11
OPERATING GUIDELINES
NOTES:
1. Hot Air Gun Temperature is adjustable between 100°
and 480°C with an increment of 2° on each step.
2. Hot Air Gun Airflow Rate is adjustable between 10
and 100 with an increment of 2 on each step.
C. SOLDERING IRON
1. Connect the Soldering Iron connection assembly to the 6-pin
receptacle located at the front of the control panel (“7” from the
CONTROL PANEL GUIDE).
2. Follow the initial procedures (“A. INITIAL PROCEDURES”).
3. Connect the vacuum tube to the Smoke Absorber Terminal or
Vacuum Cap (“6” from the control panel). If smoke absorber
function is to be used.
4. Activate the “SOLDER IRON” Activation switch (“9” from control
panel). This will automatically start to increase the temperature of
the soldering iron to 350°C (default).
5. Adjust the soldering iron temperature using the SOLDER/DESOLDER
TEMPERATURE ADJUSTMENT buttons (“4” from the control panel).
6. If smoke absorber function is to be used. Activate the “SMOKE
ABSORBER” Activation switch (“11” from the control panel).
7. Start using the soldering iron as soon as desired temperature is
reached.
8. When the task is finished, deactivate the SMOKE ABSORBER switch.
9. Deactivate the SOLDER IRON activation switch.
10. Allow sufficient time for the soldering iron to cool down before
keeping in a safe storage.
D. DESOLDERING GUN
1. Connect the De-soldering gun connection assembly to the 6-pin
receptacle located at the front of the control panel (“7” from the
CONTROL PANEL GUIDE).
2. Follow the initial procedures (“A. INITIAL PROCEDURES”).