Instruction manual

8
ASSEMBLY and PREPARATIONS
Figure1.Solderingironstandwithsolderwireholder
A.MainStation
As soon as the equipment has been removed from the package,
REMOVE THE SCREW locatedatthecenterofthebottomofthe
mainunit.Thisscrewholdsthepumpinplaceduringtransportation.
B.SolderingIron
1. InstallthesolderwiretothesolderingironholderasinFigure1.
2. Connect the soldering iron cord assembly to the 6pin output
terminalfoundatthelowermiddleportionofthemainunit.
3. Place the soldering iron to the soldering iron stand as shown
above.
C.SmokeAbsorber
1. Attach the smoke absorbing tube to the suction vacuum cap.
Makesurethecordconnectionsarefreefromtangles.
D.HotAirGun
TheHotAirGunholderwasinstalledonthestationupsidedownfor
packagingpurpose.TosetuptheHotAirGunholder:
1. Loosenthetwoscrewsthatsecuretheholdertothestation.
2. Turntheholderrightsideup.
3. Refastenthetwoscrews.
4. Placethehotairgunontotheholderinpreparationforusage.
E. DesolderingGun
1. Connectthecordofthedesoldering guntothe6pinterminal.
2. Connectthevacuumtubetothesuctionvacuumcap.
3. Place the desoldering gun onto the holder in preparation for
usage.
WARNING: Failure to remove the screw before using the
equipmentcancausedamagetothesystem.
25
CARE and MAINTENANCE
4. Inside the pipe, the quartz glass and heat insulation are installed.
Loosenthecableandtakeouttheheatingelement.
5. Insertnewheatingelementandreconnecttheterminal. Becarefulnot
torubHeatingElementwire. 
6. Reconnectthegroundwireafterreplacingtheelement.
7. Assemblethehandleagain.
SolderingIronErrorMessages
1. Soldering Iron connection assembly is not connected or not
properlyconnectedtothereceptacleonthecontrolpanel.
2. Soldering iron tip is damaged and needs to be replaced. The
devicewilldisplay“PLUG”.
3. Indicating a problem with thecontacts of the soldering iron or
thetip.
DeSolderingGun
1. Beforeusagedampenthefilterpadswithalittlebitofwatertoallowefficient
air passage and filter action, redampen pads frequently for maximum
efficiency.
2. Routinely clean  Spring Filter, and replace filter padswhen they are dirty or
clogged.
3. ThesolderpathwaycanbecleanedusingtheprovidedNozzlecleaningpin,use
thecleaningpinwhenpathwayseemsclogged.
DeSolderingGunDisassembledillustration:
Filterbarrel
cap
SpringFilter
FilterBarrel
FilterPads
FilterDock
DesolderingGunBody
Heating
element
Nozzle
Securinglock
Heaterexternal
housing