Instruction manual

20
CARE and MAINTENANCE
Blower/Vacuum Air Terminal Filters
Filtersshouldbecleanedandreplacedregularlytoavoiddirtwhichcan
clog the air passage. More importantly, this will also effectively clean
thetoxicfumesproducedduringsolderingprocess.
Soldering Iron Tip
Always keep the solderplated section of the tip/nozzle coated with a
smallamountofsolder.Oxidecoatingonthetipofthenozzlereduces
itsheatconductivity.Coatingthetipwithasmallamountoffreshsolder
ensuresmaximumheatconductivityisobtained.
Replacing the Soldering Iron tip
1. Always turnOFF mainpower switchwhenremovingor insertinga
tip.
2. Ifthetipishot,usetheheatresistantpadtopullitout.
3. Insertthenewtipfullyintothehandle.Ifthetipisnotfullyinserted
(or if the tip is damaged), the device will produce five high beep
sounds then show the following from the SOLDER/DESOLDE R
TEMPERATUREdisplaypanel(“13”).
PartNo. Description
10094 Hotairgunheatingelement
30106S Plastichandleofhotairgun
S009 Hotairguncompletehandle
20962 Hotairgunmetalpipe
B012 SolderingIroncompletehandle
C005 Desolderinggunheatingelement
3072D Plastichandleofdesolderinggun
B1003 Desolderingguncompletehandle
Spare Parts Guide
9
ASSEMBLY and PREPARATIONS
Figure1.Solderingironstandwithsolderwireholder
A. Main Station
Assoonastheequipmenthasbeenremovedfromthepackage,REMOVE
THE SCREW located at the center of the bottom of themain unit. This
screwholdsthepumpinplaceduringtransportation.
B. Soldering Iron
1. InstallthesolderwiretothesolderingironholderasinFigure1.
2. Connect the soldering iron cord assembly to the 6pin output terminal
foundatthelowermiddleportionofthemainunit.
3. Placethesolderingirontothesolderingironstandasshownabove.
C. Smoke Absorber
1. Attachthesmokeabsorbingtubetothesuctionvacuumcap.Makesure
thecordconnectionsarefreefromtangles.
D. Hot Air Gun
The H ot Air Gun holder was installed on the station upside down for
packagingpurpose.TosetuptheHotAirGunholder:
1. Loosenthetwoscrewsthatsecuretheholdertothestation.
2. Turntheholderrightsideup.
3. Refastenthetwoscrews.
4. Placethehotairgunontotheholderinpreparationforusage.
E. Desoldering Gun
1. Connectthecordassemblyofthedesoldering guntothe6pinterminal.
2. Connectthevacuumtubetothesuctionvacuumcap.
3. Placethedesolderinggunontotheholderinpreparationforusage.
WARNING: Failure to remove the screw before using the
equipmentcancausedamagetothesystem.